A Site for Photographers by Photographers

Community > Forums > Canon FD > Canon T70 Back-Up Battery?

Featured Equipment Deals

Transformational Imagemaking: An Interview with Robert Hirsch Read More

Transformational Imagemaking: An Interview with Robert Hirsch

Robert Hirsch takes us through history in this interview about his new book, beginning with the groundbreaking 60s to contemporary work of today, featuring artists in his book that "...literally have...

Latest Equipment Articles

4 Outdoor & Adventure Photo Packs Read More

4 Outdoor & Adventure Photo Packs

Photo packs have come a long way in the past decade, especially those that are targeted toward outdoor and adventure photographers. Alaska-based adventure photographer Dan Bailey takes a closer look...

Latest Learning Articles

25 Autumn Scenery Photos Read More

25 Autumn Scenery Photos

Fall is upon us yet again and to celebrate this colorful season, here are 25 scenes of autumn captured by photo.net members.


Canon T70 Back-Up Battery?

john lu , Aug 15, 2003; 02:17 p.m.

1). Is there a back-up lithium battery in Canon T70?

2). How to check/find/replace this battery, if there is one?

Responses

Jim Vanson , Aug 15, 2003; 03:00 p.m.

john...to the best of my knowledge there IS NOT a back up battery à la the T90's Lithium BR-1225 or CR-1220.

Duane Kucheran , Aug 15, 2003; 04:36 p.m.

The T70 has a backup battery. Christian Rollinger's site has the service manual: http://www.canonfd.com/t70service/t70service.pdf

Cheers,

Jim Vanson , Aug 15, 2003; 09:04 p.m.

Thanks to Duane Kucheran for his great information RE; a T70 does indeed contain a backup battery (and obviously it's not a Con-Ed battery...Con-Ed being NYC's electricial utility).

I've shot with the great T70 several times and have bought several of them for students. During that time I never realized that the camera did indeed contain a backup...(I always thought eprom).

So once again thanks for clearing up one big misconception (or screwup if you will) on my part!

Cheers...jim

john lu , Aug 16, 2003; 12:36 a.m.

Thanks to all of you,

The camera has been taken apart and, indeed, there is a battery of a size of about half an inch, the battery was soldered onto the flex with two ss contact.

The voltage of the battery is 3.44 V, is this the correct voltage or it is too low?

If the battery is not the cause of my problem, then what could cause the LCD goes to blank while the camera is switched off?

Another question is that is there a reset mechanism that would reset the electronics to factor default state?

Thanks again!

Back to top

Notify me of Responses